Solenoid Valve Normally Closed 1/2″
KSh1,000.00
Specifications
- Voltage: 12VDC,24VDC,220VDC
- Media Temperature Range: 10C-750C
- Coil Resistance: 4.75KΩ±0.25KΩ (Temp.200C)
In stock
DESCRIPTION
Control the flow of fluid using the flow of electrons! This liquid valve would make a great addition to your robotic gardening project. There are two 1/2″ (Nominal non-taped National Pipe) outlets. Normally, the valve is closed. When 12VDC is applied to the two terminals, the valve opens and water can push through. The valve has a gasket arrangement inside, so there is a minimum pressure requirement of 0.02 Mpa (3 PSI). Also, liquid can only flow one direction.
We tried this solenoid at various DC voltages and found we could actuate it down at 6VDC (although it was a little slower to open). Here is the current draw table for various voltages. We suggest a TIP120 or N-Channel power FET with a 1N4001 kickback diode to drive this from a microcontroller pin. For a power supply, our 9V 1A or 12V 1A power adapters will do the job.
Specifications:
- Material: metal + plastic
- Voltage: DC 12V
- Power consumption: 8W
- Current: 0.6 A
- Input and output: 1/2 ” (outer diameter)
- Pressure: 0,02 – 0,8 Mpa
- Maximum fluid temperature: 100 °C
- Operating mode: normally closed
- Valve type: diaphragm
- Application:Water, Air, Natural Gas, Low Viscosity Fluid, etc.
Package includes:
1 x solenoid valve 1/2″
Related products
Relays, Motors, Motor drivers, Pumps & Valves
L293D Motor Drive Expansion Shield Board Module/H BRIDGE For Arduino
Relays, Motors, Motor drivers, Pumps & Valves
Relays, Motors, Motor drivers, Pumps & Valves
Relays, Motors, Motor drivers, Pumps & Valves
Relays, Motors, Motor drivers, Pumps & Valves
5V 2 Two Channel Relay Module DC 5V + Optocoupler For Arduino PIC ARM AVR DSP