STEPPER MOTOR 5VDC UNIPOLAR
- This is a great first stepper motor, good for small projects and experimenting with steppers.
- This uni-polar motor has a built in mounting plate with two mounting holes.
- There are only 32 step (11.25 degree) per revolution, and inside is a 1/16 reduction gear set.
- (Actually its 1/16.032 but for most purposes 1/16 is a good enough approximation) What this means is that there are really 32*16.032 steps per revolution = 513 steps!
- The shaft is flattened so its easy to attach stuff to it with a set-screw.
- A perfect first stepper motor and works well with the Motor Shield for Arduino.
- The gearing has a few side effects which are important to note.
- First, you can turn the stepper by hand but not as smoothly as an un-geared stepper.
- It also means you shouldn’t use interleaved or micro-stepping to control or it will take forever to turn.
- Instead use single or double stepping.
- The torque is fairly high but its slower than un-geared steppers – we maxed out at about 80 RPM when powering with 12VDC and about 50 RPM on 9VDC.
Specifications STEPPER MOTOR 5VDC UNIPOLAR
- Unipolar stepper with 0.1″ spaced 5-pin cable connector
- 32 steps per revolution
- 1/16.025 geared down reduction
- 5V-12V DC suggested operation
- Weight: 37 g.
- Dimensions: 28mm diameter, 20mm tall not including 9mm shaft with 5mm diameter
9″ / 23 cm long cable
- Holding Torque @ 12VDC: 250 gram-force*cm, 25 N*mm/ 3.5 oz-force*in
- Shaft: 5mm diameter flattened
Relays, Motors, Motor drivers, Pumps & Valves