STM32F401 Development Board V3.0 STM32F401CCU6

STM32F401CCU6 core board V3.0

Freq. 84Mhz  ROM:64 KB RAM:256 KB

Core Board Information

25MHZ high speed crystal oscillator & 32.768Khz 6PF low speed crystal oscillator

V3.0 version began to use lead-free process, the pin header is gold-plated pin header, more environmentally friendly

Flash pads have been reserved and USBDisk && FATFFS routines are provided

Support MicroPython programming, provide available MicroPython firmware, see the link for configuration files, but do not provide technical answers!

Support Arduino programming, see Github https://github.com/stm32duino/Arduino_Core_STM32 for details

 Boards with version V1.3 and above have 3 buttons, reset button, BOOT0 button, and user buttons.

How to enter ISP mode

    Method 1: Press and hold the BOOT0 button and the reset button under the power-on state, then release the reset button, and release the BOOT0 button after 0.5 seconds

    Method 2: Hold down the BOOT0 key when power is off, and release the BOOT0 key 0.5S after power on

    DFU mode: just use the data cable to connect to the computer, if there is a problem of unrecognized, you can properly heat the chip (25 ° C), and then re-enter the ISP mode

    Serial port mode: use USB to serial port to connect PA9 and PA10 of the core board

    Software: STM32CubeProg.

           No need for USB to serial port, no debugger, no computer driver, just a TYPE-C data cable to complete the firmware download

How to enter HID Bootloader after writing to APP

Press and hold the KEY button, click the reset button, LED C13 flashes, release the KEY button to enter