No products in the cart.
TP5410 LiPo Battery Charger and Boost board Shield
KSh400.00
In stock
Description
TP5410 LiPo Battery Charger and Boost board Shield for WeMos D1 Mini,
The WeMos lithium battery shield provides a means of powering your microcontroller project from a single cell (3.7V) lithium battery. The shield contains a DC-DC converter to step-up the batteries 3.7V to 5V supplying your WeMos mini and shields with up to 1A of power. When the battery is depleted simply plug the shield into a USB power source using a micro USB cable and it will automatically recharge the battery. Two LEDs on the shield indicate when the battery is charging and when charging has completed.
Technical characteristics
- Charging voltage: nominal 5V (max 10V)
- Load current: 0.5A by default. Solder the jumper J1 to increase to 1A (be careful, check the compatibility with the battery before any modification)
- Supported Lithium Battery: 3.3 to 4.2V
- Voltage converter up to 5V (max. 1A)
- Battery connector in JST XH2-2.54mm
- Micro-USB connector (OTG) for recharging (5V, max 10V)
- Green Led: On when charging is complete
- Red Led: On during charging
- Jumper J1: Increases the load current from 0.5A to 1A
Features TP5410 LiPo Battery Charger
- Charging Voltage: max: 10V, recommend: 5V
- Charging Current: max: 1A
- Lithium Battery voltage: 3.3-4.2V
- Boost Power Supply: 5V(max: 1A)
Pins
| D1 mini | Shield |
|---|---|
| 5V | 5V(max: 1A) Power Supply |
| GND | GND |
Ports
| Port | Introduction |
|---|---|
| PH2-2.0MM (Port 1) | Connect to lithium Battery (normal 3.3-4.2V) |
| Micro USB (Port 2) | Charging port (normal 5V) |
| Green LED | lights when charging is completed |
| Red LED | lights when charging |
| J1 | setting max charging current, 0.5A or 1A. |
| J2 | Connect battery to A0 |
Documents
Related products
Out of stock
Out of stock
Out of stock
Out of stock
Out of stock
Out of stock
Out of stock